Skip to content

Court Builders

Tennis Court Installation in Los Angeles County

A finished court that plays true, drains cleanly, and holds up to year-round Southern California sun.

  • On-Site Assessment
  • Itemised Estimate
  • Final Walkthrough
  • All of LA County
Aerial view of multiple illuminated tennis courts at night with bright floodlights.

Build It Right

Where rushed tennis court builds fail, and what a careful build does differently

Skipped Subgrade Work

Clay-heavy soils that shift seasonally will crack a slab from below if the subgrade is not inspected and prepared before base work starts.

Subgrade Inspection First

A slope check and soil assessment happen before any excavation, with subgrade prep listed as a separate line item in the written estimate.

Compressed Cure Times

Applying acrylic coats before the previous layer has fully cured is a leading cause of surface delamination within the first few seasons of use.

Full Cure Between Coats

Each acrylic layer is allowed to cure completely before the next coat is applied, protecting the surface bond over years of outdoor use.

Drainage Added Late

Drainage that is retrofitted after the base is laid rarely integrates cleanly, leaving low spots where water pools and accelerates surface wear.

Drainage Set at Base Stage

Drainage provision is designed and installed during base construction, not added afterward, so water clears the court surface as intended.

Unaddressed Slope

Many Los Angeles County residential lots have sloped terrain; building a base on ungraded ground produces an uneven playing surface and standing water.

Grading Before Base Work

The site is graded to establish a level plane before any base material is laid, so the finished surface meets the slope tolerance required for true play.

Common problems, answered

Scope of Work

What a full tennis court installation covers

Every phase from raw ground to a playable, marked court, each itemised in the written estimate before work begins.

Residential Backyard Courts

Single-family lot builds with grading and drainage.

HOA & Community Courts

Multi-court builds for shared residential facilities.

School & Club Courts

Campus and club builds with fencing and lighting.

Court Replacement Builds

Full rebuild where an existing surface is beyond repair.

End-to-End Build

A tennis court that plays true starts with the ground beneath it

Rushing or skipping site prep causes cracking, pooling water, and uneven bounce, problems that cost more to fix than to prevent.

Request an Assessment

The builder starts with a subgrade inspection and slope check. Southern California’s clay-heavy and expansive soils require careful assessment before base work begins, clay that shifts seasonally can crack a slab from below if the subgrade is not properly prepared. Many Los Angeles County residential lots have sloped terrain that needs grading before a level court base can be established. The written estimate covers subgrade work as a separate line item so the scope is clear before any excavation starts.

Base installation follows grading. A concrete slab or asphalt base layer is laid over the compacted subgrade, with drainage setup integrated at this phase. Acrylic surface coating is applied in layers over the cured base, with UV-stable formulations chosen to handle year-round Southern California sun. Each coat is allowed to cure fully before the next is applied, compressing cure intervals to save time is a common cause of surface delamination within the first few seasons.

Perimeter fencing, net posts, and center strap anchors are installed after the surface cures. Regulation line marking is the final step, applied over the finished acrylic surface using court-grade paint. A drainage check and surface slope verification are completed before the job is signed off. The written estimate itemises grading, base, surfacing, fencing, net posts, and line marking separately so every phase is visible before work begins.

Why Choose Us

Why Los Angeles County Sports Courts for tennis court installation?

Court-focused builders, a written scope before any work starts, and a final sign-off process that confirms the surface is ready to play.

Written Scope Before Excavation

Subgrade prep, base, surfacing, and fencing are each listed before a shovel goes in the ground.

On-Site Assessment Included

The ground and drainage are checked before any booking is confirmed or estimate issued.

Court-Focused Builders Only

The scope covers sports court work specifically, not as a side job inside general contracting.

Final Walkthrough Before Sign-Off

Surface slope and drainage are verified on completion, the job is not closed until both pass the check.

All of LA County Covered

We arrange builds for backyard, HOA, school, and commercial sites across Los Angeles County.

Aerial view of multiple illuminated tennis courts at night with bright floodlights.
Finished regulation tennis court with acrylic surface and crisp white line striping backyard

The Process

From first enquiry to a finished, playable court

Request an Assessment

  1. 01

    Submit Your Site Details

    Tell us the location and intended use so we can arrange the right local court builder for your site.

  2. 02

    On-Site Assessment & Estimate

    The site inspection covers the ground and drainage, and leads to an itemised written estimate covering every phase.

  3. 03

    Build, Cure & Sign Off

    Work runs from grading through to line marking, with a final slope and drainage check before handover.

Pricing Estimates

Typical Tennis Court Installation Prices

Project typeTypical estimated cost
Outdoor tennis court, basic build$80,000-$120,000
Outdoor tennis court with fencing and lighting$120,000-$180,000
These prices are estimates and often vary with the condition, size and scope of each job. Message or call us for a free, no-obligation quote.
See all prices

Common Questions

Tennis court installation questions, answered plainly

  • How much does it cost to install a tennis court?

    Most tennis court installations in Los Angeles County come in at $80,000-$120,000, depending on site conditions, surface type, and whether fencing and lighting are included. Flat, accessible lots with stable soil sit at the lower end. Sloped or rocky ground requiring significant grading pushes costs higher.

  • What makes a tennis court installation cost more or less?

    Site conditions drive the biggest swings. Steep grading, poor drainage, or unstable soil all add base preparation work before surfacing can begin. Surface choice matters too, cushioned acrylic costs more than plain asphalt. Fencing height, lighting, and line marking each add to the total, and tight access for equipment raises labor time.

  • How much space do I need for a tennis court and the runoff area?

    A regulation singles court measures 78 feet by 27 feet, but you need runoff clearance on all sides. The recommended minimum total footprint is 120 feet by 60 feet for recreational play, and 120 feet by 66 feet for competitive play. Anything tighter limits safe movement and ball retrieval behind the baseline.

  • Can my yard fit a tennis court at all?

    You need roughly 7,200 square feet of usable, relatively flat ground as a starting point. Setback requirements, easements, and slope all reduce what counts as usable. An on-site evaluation is the only reliable way to confirm fit. The site assessment covers space and drainage before anything is booked, so you get a clear answer upfront.

  • Do I need grading or major site prep before the court can be built?

    Almost every site needs some grading. The base must be compacted, level within a tight tolerance, and sloped slightly for drainage. Yards with significant elevation changes, clay-heavy soil, or poor drainage require more extensive earthwork before the base aggregate and surface layers can go down. Court design and site preparation covers this scope.

  • Will the court need drainage work so it does not pool water?

    Yes. Every court needs a deliberate drainage plan. The base is graded with a slight cross-slope so water runs off the playing surface rather than pooling. On sites with clay soil or low-lying areas, subsurface drainage channels or French drains are added. Poor drainage is the leading cause of surface cracking and early court failure.

  • How do you keep a tennis court from cracking later?

    Cracking almost always starts with base failure or drainage problems, not the surface itself. A properly compacted aggregate base, correct drainage slope, and quality acrylic coating applied at the right thickness all reduce crack risk significantly. Sealing hairline cracks early and resurfacing on schedule prevents minor movement from becoming structural damage.

  • Do you handle leveling, base work, and surface finishing as part of the job?

    Yes. The itemised estimate covers base preparation, surfacing, fencing, lighting, and line marking as a complete scope. Grading and compaction happen first, then the aggregate base, then the surface coating and markings. Nothing is handed off mid-project. The same contractor carries the job through to the final walkthrough.

More questions about Tennis Court Installation?

Tell Us Your Site & Sport

We schedule a ground assessment, check drainage, and put the full scope in writing before anything is booked.

Request an Assessment